Flush Head Studs
Studs that press in flush, M2 to M8, lengths 5 to 50 mm.
Self-Clinching & Weld Fasteners
Concealed Head Studs
Studs fitted into a blind hole so the reverse side stays untouched.
- Section
- Self-clinching
- Type
- Studs & pins
Overview
Concealed head studs install into a blind (not through) hole, so the opposite face of the panel stays smooth, unmarked and ready for finishing.
Full dimensions, preferred lengths and installation / push-out / torque-out performance data are shown in the datasheet below, taken from the self-clinching fasteners catalogue.
Specifications
| Part numbers | KB-CHC, KB-CFHC, KB-CHA, KB-CFHA |
|---|---|
| Stainless Steel | KB-CHC, KB-CFHC |
| Aluminium | KB-CHA, KB-CFHA |
| Sizes | M3, M4, M5 |
| Sheet hardness (KB-CHC/CFHC) | HRB 70 or less |
Datasheet
Dimensions, preferred lengths and performance data from the self-clinching fasteners catalogue.
Key features
- Reverse side stays clean
- Stainless and aluminium
- No through hole needed
Applications
Front panelsDisplay casesCosmetic surfacesInstrument fascias
Need a size, grade or finish not listed?We also supply special and non-standard parts to drawing.Send enquiry
More self-clinching
Flush Head Pins
Unthreaded locating pins with a flush head, 3 to 6 mm.
High Strength Studs
Hex-head clinch studs for high torque, M5 to M10.
High Strength Studs for Thin Sheets
High-strength studs designed for thin sheet metal.
Low Displacement Flush Head Studs
Flush studs that disturb the sheet very little, close to edges.
Thin Sheet Studs
Flush studs for very thin sheet metal.